1. Read the instructions carefully before using the tablet press for the first time, and then use it.

2, the machine can only be operated in a certain direction (see the arrow on the handwheel or the protective cover), can not be reversed, so as not to damage the machine, especially in the adjustment of the tablet, do not neglect.

3, belt elastic adjustment: through the two adjustment nut on the electromechanical bottom plate to adjust, after adjustment, pay attention to locking.

4. When the power is not applied, the triangle belt should be removed to reduce the resistance and wear, but the large pulley should not be removed, because the large pulley has the function of the flywheel.

5. When turning on the electric tablet, the rotating handle on the handwheel must be pulled down to avoid injury when running.

6. Regardless of manual pressing or electric pressing, before starting the tableting machine, the upper punching rod should be in the rising position and then restarted. If the upper punching piece is started in the lowered position, it will start immediately after starting. The middle mold is pressed, and at this time, since the rotation speed of the machine has not risen, the inertia is small, and the situation of the top car is likely to occur.

7, after the car after the treatment: (1) in the case of electric pressing, the car should be turned off immediately, so as not to burn the motor.

(2) When the top car is light, you can use the hand to turn the handwheel to make the upper punch pass the "dead point" (but not reversed, so that the feeder does not repeat the feeding, resulting in a more serious top car).

(3) When the vehicle is severely jacked, loosen the connecting rod lock nut, turn the upper punch rod to raise it to reduce the pressure, then turn the hand wheel to push the medicine out, then re-adjust the hardness of the tablet.

8. Always check the quality of the tablets (sheet weight, hardness, surface finish, etc.) in the process of tableting.

9. The batch granulation process before the tablet press has a great influence on the tableting, such as the formulation granulation of the materials and the materials such as the slip material, the filler, the binder, etc. (the condition of the powder, the granules, the powder, the powder) The proportion of the granules, the water content, etc., all directly affect the amount of the tablet, and often cannot be formed into pieces due to improper granulation of the ingredients, or even damage the machine.

Mushroom Slices In Jar

Mushroom Slices In Jar,Whole Mushroom In Canned,Fast Food Canned Mushrooms,Fast Fresh Whole Mushroom Canned

ZHANGZHOU TAN CO. LTD. , https://www.zztancan.com