Three-in-one filling machine use process and notes

First, three-in-one filling machine boot preparation

1. Check the lubrication part of the equipment before starting the machine. If there is no lubricating oil in the oil cup and gear, you must add the corresponding lubricating oil.

2, Check whether the parts of the equipment are frequently loose. If it is necessary to tighten, please pay attention to whether its position changes. Generally, it must be operated at low speed and then run automatically.

3. Check if the liquid level of the wash tank is sufficient. If there are any tools or other things missing on the equipment, you must ensure safety before running.

4. Whether the valves in all parts are in normal condition, whether the air pressure meets the requirements of the equipment.

Second, three-in-one filling machine precautions

1. During operation, pay attention to whether the device has an abnormal sound. If it is necessary to repair it, find out the cause and clear the fault.

2. It is strictly forbidden to stand on the equipment when the equipment is running.

3. Check if the UV lamp disinfected by the cover is open, whether the cover of the cover is ozone-added, and whether the pure water pump for disinfection has normal water supply.

4. If the filling valve leaks, there are two possibilities: one is that the filling valve is opened and not reset, and the other is that the sealing ring of the filling valve is not sealed.

5, If there is a high cover and a lid, there are the following situations: First, there is a problem with the cooperation of the lid and the bottle, and there may be a problem with one of them. Second, the capping head has insufficient torque, if it can be rotated by hand, Then find out the capping head to increase the torque until it meets the requirements. Third, there is a problem with the upper bottle, mainly in the excessive position of the star wheel. It is possible that the bottle retaining block is loose and must be reset.

6, if the bottle is removed from the bottle, there are the following conditions: First, there is a problem with the bottle on the bottle mouth. Second, the spring of the bottle holder has lost its elasticity, or the bottle is loose or worn, and there is no way to pinch the bottle. Replace it.

7. If the torsion force of the capping head is not adjusted, replace it with a magnet, and then check the spring inside. If the elastic force is not enough, it should be replaced. In addition, the capping cap must not be removed after the gland is closed. Replace the parts.

8. If the cover is always blocked at the small star wheel of the cover slot, the position of the star wheel must be adjusted until it is smooth. If the cover of the cover machine is covered, first check whether the components at the exit are covered, and blow the cover. Is the air pressure too large, then adjust its position or air pressure.

9, the capping machine if the dial is not smooth, you can turn up or adjust the spring pressure on the dial plate, and also check whether the excessive contact with it is normal.

The above list is just some of the problems encountered by Reston Beverage Machinery Company in purchasing the three-in-one filling machine customers in the production process. It is also a part of the experience. The specific problems have to be analyzed in detail. Of course, some have not said that. You need to find the problem analysis problem to solve the problem yourself. If there are any difficult problems in the production process, Zhangjiagang Ruiston Beverage Machinery Co., Ltd.