In the coming of the Three Summers, all kinds of agricultural machinery must go to their jobs. To ensure proper driving and safe operation, all types of agricultural machinery accidents should be minimized and the service life of the equipment should be extended. The following issues should be taken into account when using agricultural machinery in summer: 1, pay attention to prevent the engine temperature is too high. If the engine is “opened†during use, most of the cases are water shortage in the water tank. However, cooling water cannot be added immediately. Otherwise, the cylinder head or cylinder may burst and people may be burned. The correct way is to stop the operation, run at low speed until the water temperature drops to about 70C, and then slowly add clean cooling water. 2, pay attention to prevent the use of oil. Lubricating oil viscosity varies with the temperature, and the viscosity decreases when the temperature rises. In summer, ECA-30 or ECA-40 diesel engine oils are used. 3, pay attention to prevent the tire pressure is high. As the temperature rises, the air increases in volume and tends to cause tire bursts. Inflating tires in summer should be 5%-7% lower than in winter, and never exceed the standard tire pressure. 4, pay attention to prevent the engine tank scale is too thick. If the engine water jacket is too thick, the heat dissipation efficiency will be reduced by 30% to 40%, which may cause the engine to overheat and the power to decrease. Therefore, the scale must be regularly cleaned to maintain good cooling performance. 5, pay attention to prevent the fan tape tightness loose. Under high temperature operation, the tension of the tape drops, causing the tape to slip, the transmission efficiency to decrease, and the tape being easily damaged. Therefore, in the summer, the tension of the cold-adjusted engine belt is slightly higher than the standard value. 6, pay attention to prevent oil brake pipe air resistance. In the summer of high temperature, the oil brake brake pipeline is prone to air resistance, which seriously affects the braking effect. Therefore, in use, one must ensure sufficient brake fluid, and secondly prevent pipeline leakage, and the third must be timely when air resistance occurs. Drain the air. 7, pay attention to prevent the fuel system air resistance. Once the fuel produces air resistance, it should immediately stop cooling, and pull the hand pump to eliminate air, so that the oil is full of fuel. 8. Take care to prevent the circuit oxidation from malfunctioning. 9, pay attention to prevent the lack of battery water. 10. Take care to prevent fire. Always check the fastening of the wires and the fuel pipe fittings to prevent sparks due to poor contact or fuel pipe leakage.
Medical Cold Patch
Patch For Diarrhea,Medicated Patches For Arthiritis,Plaster For Diarrhea,Pad For Diarrhea Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.xjplaster.com
Patch For Diarrhea
[Name] Medical Cold Patch
[Package Dimension] 5cm 4pieces/box
The Pain Relief Patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give a fast relief for diarrhea.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.