Wetting Agent Surfactant,Anti-Drift Adjuvant,Drift Control Adjuvant,Sray Adjuvant Jiangxi Tiansheng New Materials Co.,Ltd , http://www.jxtsxcl.com
Pressure instability If the switch is not turned on, the pressure on the pressure gauge fluctuates. The reason for this is due to air leaks at gas pipelines, switches or fittings. The treatment method is to check the leakage of the entire gas pipeline section by section. If the pipe leaks, replace the new pipe and switch the leak. If the connector leaks, tighten it. If the pressure fluctuates up and down when using gas, the firepower will be unstable at large and small. The reason is that there are condensate in the gas pipeline, which makes the gas flow blocked. Treatment method: First, use the mouth to blow out or use the air pump to press out the condensed water in the pipeline, and then straighten the pipeline so that it forms a slope of 3%, so that the condensed water can naturally fall into the pool. If the gas pipeline is too long, it is best to place a condensate processor at its lowest point.
The burning fire is not prosperous. In the normal production of gas, the fire is not prosperous when burning, and the flame is red and yellow. The reason is that the biogas is not pure, the content of methane is small, or the air in the biogas stove is insufficient, no exhaust hole is provided, carbon dioxide and steam cannot be discharged outside the stove, and the biogas cannot be fully burned. Treatment methods: First, increase the fermentation of raw materials and strains, while adding lime water to increase the methane content and biogas quality; the second is to open gas exhaust hole in the gas stove, or put the stove in a smooth air position to use.
The pressure and the air volume are small. Under the high pressure conditions, the combustion is normal when used, but the pressure drops quickly, and the pressure rises quickly after closing the switch. The main reason is that there is too much liquid in the pool and the volume of the air box is reduced. Despite the large pressure in the air box, the amount of stored air is not large. The treatment method is to take a part of the liquid in the pool to increase the volume of the air box. When entering and leaving the material, you should pay attention to how much you get out of it.
When the rate of gas production declines, the normal gas producing pool begins to produce, and the rate of gas production will gradually decrease or suddenly drop. The gradual decline is due to the gradual increase of the old material deposited at the bottom of the pool, and the effective pool capacity is gradually reduced. Treatment method: The old material in the lower part of the pool can be partially removed from the discharge port, and then the new material can be added. Sudden declines are usually caused by leaks in tanks or air tanks, blockages in gas transmission systems, or large amounts of toxic substances in the tank. Approach: First check the gas system is blocked. If it is not blocked, the liquid in the tank should be drained out, and the tank and air box should be overhauled and then fed again.
The multi-burn non-combustible pressure gauge shows that the gas pressure is high, but the emitted gas cannot ignite. The main reason is that there are few kinds of methanogenic bacteria in the biogas tank or the acidity of the fermentation liquid is too large, which inhibits the growth and reproduction of methanogens, but produces many unburnt gases. Disposal methods: First, single out one-third of the pool's volume of liquid, add 10 to 15 tons of activated sludge or normal old gas digester water; second, add 1 to 2 kg of lime per cubic meter of feed solution. acidity.