Meat grinder safe operation

1. After connecting the power supply, first look at the output shaft of the meat grinder to see if the steering shaft is turned correctly. The correct turning of the meat grinder is counterclockwise rotation. It is strictly prohibited to rotate in the opposite direction. After the test is turned on, the power is cut off and the assembly is zero. Parts can be used, otherwise parts will be damaged.

2. Before the machine starts, the ring should not be tightened too tightly. After starting, the ring can be adjusted to the appropriate level at any time. The meat is normal when the machine is running normally. All kinds of meat must be peeled and boned before being twisted. The meat pieces are long strips, which can improve the efficiency of ground meat. Do not drop foreign objects into the meat barrel before use and during use to prevent accidents.

3. When using the meat block to stop at the feeding port, do not use your hand to smash it. Use the raft to press it. If there is a jam, you should quickly press the red button to stop. After the fault is removed, you can continue to use it. . Note: When troubleshooting, you must pull off the power to prevent accidents.

4. If you find that the V-belt is too loose or too tight during use, you can loosen the rear adjustment nut to adjust the motor position. After fitting, tighten the nut.

5. After the machine is used up, in the case of complete power failure, remove the parts in turn, clean them and put them back for use next time.

6, the operation should be concentrated, it is strictly prohibited to chat, chat, play and play.

7. After the machine is used up, it must be powered off and cleaned. You must check if the power switch is disconnected before leaving work.