The chair side CAD / CAM repair system has obvious advantages in aesthetic effect, operation time, patient participation and operation convenience. Discussion: traditional repair method: after the model is transferred, it will be sent to the technician's room for processing and making the final prosthesis. About one week, the final prosthesis will be tried on, grinded and bonded. The prosthesis was made in the technician's room. The patients need to accept the aesthetic effect of the prosthesis passively without any sense of participation. The implant repair method of chair side CAD / CAM system: obtain computer three-dimensional model by blue light scanning method, design and make personalized abutment and all ceramic restoration on computer, dye, glaze and bond after trial wearing, the whole restoration is made by chair side, patients can directly participate in the restoration design, and feel more involved. Conclusion: in the implant area of the anterior teeth, compared with the traditional implant repair method, the chair side repair system can get more satisfactory results, which is worthy of clinical application and promotion. Desktop Type Dental Milling Machine Dental Equipment For Lab,Dental Implant Milling Machine,Titanium Dental Milling Machine,Glass Ceramic Dental Milling Machine Shandong Carved Intelligent Technology Group Co.,Ltd , https://www.demetdent.com
First, prenatal preparation can be produced in a warm place out of direct sunlight. Discarded food containers, plastic bags and other containers can be used. Cover materials with clean towels, gauze, etc. Second, the disinfection of containers and utensils into the water scald 15-30 minutes, remove and dry after drying. Dishwasher disinfectants can also be soaked for 10 minutes and then rinsed with water. Third, the selection of species with thick skin, 1000-grain weight of more than 700 grams of fine varieties, the selected seeds of high maturity, full of seeds, no pests, high germination rate, high purity, and is a new seed. 4. After thoroughly washing, the broad beans are soaked in water at 60°C for 10 minutes, then soaked in cold water for 30 hours, and rinsed and replaced with water every 5-6 hours. After the end, wash off the adhesive and dirt on it, then remove it and drain it. 5. Incubate the immersed broad beans in a cultivating container, cover them with gauze or towels, and place them in a place protected from light and moisture. After 6 hours, inject water into the incubation vessel (water should spill over the surface of fava beans), dip for 2-3 minutes, tilt the vessel, and pour the water. Repeat twice, drain the water and cover with a towel or gauze. 6. Harvesting When the bean sprouts are 1 cm long, they can be harvested. At this time, nutrition and quality are the best.