Currently, two-piece dry-friction clutches are used on small four-wheel tractors and three-wheeled transport vehicles. This type of clutch is easy to disassemble, but it is troublesome to install. Here are some installation experience. (1) When installing the driven friction plate assembly, the short end of the hub of the two driven plates should be opposite. If the two long hubs or a long hub end is mistakenly opposed to a short hub end, the movable piece will be suspended in the middle of the two driven plates and torque cannot be transmitted to make the clutch slip. (2) Clutch inner and outer bearings (60206 and 602024 bearings respectively) are all single pentagonal concentric ball bearings with anti-oil caps. They must be installed so that the sides of the two bearings with the oil cap face the clutch cavity to prevent The grease in the bearing is thrown into the surface of the friction plate during operation, causing the clutch to slip. (3) When there is no special tool assembly, three small springs can be compressed by 20-22 mm and tied with cotton thread symmetry, and then the bundled small spring dust-proof circles are respectively put on the three separate armature rods; Remove the thread after the clutch is installed. (4) When tightening the 6 nuts on the shell cover, tighten it several times according to the diagonal. After tightening, the end of the groove must not protrude beyond the side of the grooved groove so as not to touch the belt. (5) When installing the release bearing, the side with the thrust circle should be oriented towards the release lever, otherwise it will exacerbate the separation lever wear. (6) When installing the clutch release claw seat, make sure that the oil collection slot is directly below to prevent the lubricant from being thrown into the clutch case and cause the belt to slip. (7) After the equipment is installed, push the clutch shell along the axial direction by hand. There should be no obvious shaft movement at this time. Otherwise, the inspection should be disassembled. New Product Vape Pod,Battery Veiik Vape Pod,Battery 2Ml Electronic Cigarette,Pod System Vape Pod Shenzhen Wanna Technology Co.Ltd , https://www.veiikvape.com