Our organic vegetable powder mainly used dehydration technology. Dehydration vegetable powder remained most fiber and taste of fresh vegetables, so they are suitable to be added in sauce, stuff, pudding, yogurt and dessert. Some vegetable powder could be applied as pigment like red beet root powder. Some could be mixed with other super green powders to make health formula, kale powder and broccoli powder are always good choice for customers.
Vegetable Powder,Red Beet Root Powder,Broccoli Powder,Organic Vegetable Powder YT(Xi'an) Biochem Co., Ltd. , https://www.ytlinkherb.com
Header plugging is a common fault in the combine harvester and it often affects the normal operation of the harvester. The header does not work when severe. Therefore, attention must be paid to the prevention of plugging of the header. The methods are as follows: 1. Harvested crops should be dry, not too wet and dew. The height of the crop needs to be above 55mm, otherwise it will make the crop uprooted, blocking the stem end chain, and it is not easy to thresh. The lodging angle should meet the requirement of cutting below 85 degrees and undercutting below 70 degrees. Harvesting excessively fallen crops can make headers clogged. When harvesting, the cutting width should be reduced and the speed should be reduced. Observe the observation and find that the traffic jam is cleared in time. 2. Keep driving as straight as possible while harvesting. Due to the bending operation, the branch straws of the tiller can easily overwhelm the crops to be harvested, causing the crops to be disorderly and blocking when the abutment feeders are transported. 3. Reasonably control the feeding amount of harvested crops. If the yield of harvested crops is too high, reduce the cutting width and reduce the speed, so as to avoid clogging due to excessive load. The bifurcation device should be restored to the correct width in time after the collision deformation, to prevent the width from being too large and cause the increase in the amount of feed and cause clogging. 4, cutting knife should be kept sharp. Dirt and weeds should be removed after harvesting every day. Check and adjust and replace the worn cutter in time. Keep the gap between the fixed knife and the movable knife within 0-0.5mm. 5, support chain should maintain a good degree of tension. After the abutment cover and supporting claws are worn, they should be replaced in time to ensure that the crops are not unhandled. 6, often to maintain the claw belt, abutment chain, stem end chain, spike end chain, depth, etc. in a good state of tension, too loose should be adjusted in time, excessive wear should be replaced. 7. When the header is blocked, it cannot be forced through the throttle. This can easily damage the transmission components. The correct approach is to stop the plant quickly and manually remove the clogged crop.