YT-S350 YT-S350 Shenzhen Sunshine Technology Co.,Ltd , https://www.szyatwin.com
The main features of the circular saw:
1. The saw is mainly composed of a lifting arm, a spindle box, a motor, a hanger, a track and the like.
2, using lift cylinder control, easy to operate.
3. The headstock adopts gear reduction, directional movement and stable operation.
4. The hydraulic system is equipped with six oil cylinders to help the saw machine shift and rotate, saving time and effort.
5, using light rail, four meters, according to the job site free to move and install.
6, comes with a lifting system, you can easily and quickly replace the saw blade.
7. The integrated design of the whole machine has the advantages of high efficiency, energy saving, safety and environmental protection.
Circular saw operating procedures:
1. The workplace should be equipped with complete and reliable fire-fighting equipment. Smoking and other open flames in the workplace are strictly prohibited, and flammable products such as oil and cotton yarn are not allowed to be stored.
2. The wood to be processed and processed wood in the workplace should be piled up neatly to ensure smooth roads.
3. The machinery should be kept clean, the safety protection device is complete and reliable, the joints of the parts are tightly connected, and no debris can be placed on the workbench.
4. The safety baffle and drip device must be installed above the saw blade. Behind the saw blade, 10 to 15 mm from the tooth, a curved wedge knife must be installed. The saw blade should be installed concentrically with the shaft.
5. The saw blade must be sharply serrated. It must not be continuously missing two teeth. The crack length should not exceed 20mm. The crack end should be flushed.
6. The thickness of the sawn wood is limited to 10 to 20 mm of the saw blade. The diameter of the flange holding the saw blade should be 1/4 of the diameter of the saw blade.
7. After starting, the sawing material can be carried out after the rotation speed is normal. When feeding, the wood shall not be shaken or raised to the left or right, and the wood shall be slowly fed. The length of the saw should be no less than 500mm. When approaching the end, apply the pusher to feed.
8. If the saw wire is deflected, it should be gradually corrected, and it should not be slammed to avoid damage to the saw blade.
9. The operator shall not stand and face the centrifugal force in the direction of rotation of the saw blade, and the hand shall not cross the saw blade.
10. When the temperature of the saw blade is too high, the water is cooled and the saw blade with a diameter of 600mm or more should be sprayed and cooled during operation.
11. After the operation, cut off the power supply, lock the brake box, wipe and lubricate, and remove wood chips and shavings.
Circular saw safety technology content:
1. Entry into the site must comply with the six disciplines of safe production.
2, the circular saw must be operated by a person, the operator should be familiar with the safe operating procedures of the circular saw.
3. The circular saw should have the following safety protection devices:
a, saw blade shield;
b, feeder;
c. An adjustable metal protection baffle should be installed above the saw blade;
d. A protective cover must be installed in the transmission part.
4. Check before operation, the saw blade should not have cracks, and the screws should be tightened.
5, the operation should wear protective glasses, standing on the side of the saw blade, it is forbidden to stand on the same line as the saw blade, the arm must not cross the saw blade. The hand should be kept at a safe distance from the saw blade. It is strictly forbidden to push the saw blade.
6, the feed must be close to the mountain, not excessive force, slow push in the hard section. The cutting material should be treated with a saw blade of 15 cm and must not be hard pulled by hand.
7, the use of push rods for short and narrow materials, the use of planing hooks. Wood that exceeds the radius of the saw blade is prohibited from being sawed.