Tattoo tip is a tubes for needle go through and have different sizes based on the needle sizes. Normally,tips can be made by stainless steel and plastic.
Stainless Steel Tips can be sterile in autoclave and use many times,but plastic tips sterile packed and for disposable use.
Professional New Tattoo Tips manufacturer is located in China. Specialize In Manufacturing Wholesale Tattoo Machine Tips , Stainless Steel Tattoo Tip, Disposable Tattoo Tips, etc products. welcome to come to the consultation.
Long Disposable Tattoo Tip,Disposable Tattoo Tip,Long Tattoo Tip,Disposable Long Tattoo Tips Redtop Tattoo Supply Co., Limited , http://www.redtop-tattoo.com
In production, people are accustomed to using conventional methods to carry out eggplant seeding: first hot-pressing with hot water at 55°C, then soaking for 24 hours, after 6 days to 8 days, sprouting is about 60%, and it is not neat, because the germination time is too long. It is also easy to rot. The combination of high-temperature hot-stamping and intermittent soaking not only shortens the time for budding, but also makes the buds thick, with no rotting buds and bad seeds. The technical points are now described as follows: Seed treatment The seeds are first decontaminated, soaked in warm water at 25°C for half an hour, and then washed repeatedly to remove the pectin substance from the seed coat. High-temperature hot seeds first soaked with a little cold water treated seeds, then add about 90 °C hot water, so that the water temperature reached 75 °C, and maintain 5 minutes (when the temperature is reduced to make up the heating water, stirring quickly to avoid the scald seed). After the water temperature dropped to 30°C, it was placed in a greenhouse and soaked. High-temperature hot seeds can quickly soften the seed coat, increase cracks, and promote the respiration of embryo cells. Intermittent seed soaking seeds at a temperature of 30°C for 6 hours before soaking the seed, then drying, drying for 8 hours to 12 hours, soaking for 45 hours, re-drying for 8 hours to 12 hours, and then touching the hands to cool and not sticking Start germination. This process makes water slowly immersed into the interior of the seed to prevent the seed coat from excessively absorbing water and affecting the air permeability. This can fully meet the moisture and oxygen requirements of the seed germinating. In particular, the air film in the seed can be eliminated and the air permeability can be increased after the last airing. .