Cleaning Agent Recovery Machine Calstar® Solvent Recovery Machine Recyclable: washing solvent, acetic acid esters, halogenated hydrocarbons, three ethyl chloride, trichloroethylene, solvent oil, isopropyl alcohol, acetone, butanone and cyclohexanone, days that water, wash water gun, banana water, plate washer water, wash water network, wash water, white oil, hand washing water, diluent, washing water, ink cleaning agent, ethyl acetate, toluene, xylene, toluene three, four toluene, banana water, alcohol, ethanol, butanol, two glycol solvent waste and dirty etc.. Cleaning Agent Recovery Machine,Methyl Acetate Recycling Machine,Cleaner Recovery SHENZHEN KUANBAO ENVIRONMENTAL EQUIPMENT CO., LTD , https://www.calstarkb.com
The granule packing machine parts are lubricated. 1. The box part of the machine is equipped with an oil meter. All the oil should be refueled once before driving. It can be added according to the temperature rise and operation of each bearing. 2. The worm gear box must store oil for a long time. The height of the oil surface is all invaded into the oil. If it is used frequently, it should be replaced with new oil every three months. There is oil plug at the bottom of the sputum. 3. When the machine is refueling, do not let the oil spill out of the cup, and do not flow to the surroundings of the machine and the ground. Because oil is easy to contaminate materials, affecting product quality.
Maintenance instructions for granule packing machine 1. Regularly check the machine parts once a month to check whether the worm gear, worm, bolts on the lubrication block, bearings and other moving parts are flexible and wearable. The defects should be repaired in time and should not be used barely. 2. The machine should be used in a dry and clean room. It should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body. 3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then installed, ready for the next use. 4. When the drum moves before and after the work, please adjust the M10 screw of the front bearing to the appropriate position. If the gear shaft is swaying, please adjust the M10 screw on the back of the bearing frame to the appropriate position, adjust the clearance so that the bearing does not sound, turn the pulley by hand, and tighten it properly. If it is too tight or too loose, the machine may be damaged. . 5. If the deactivation time is long, the machine must be wiped clean, the smooth surface of the machine is coated with anti-rust oil, and covered with a cloth.
Calstar® solvent recovery machine using the distillation principle: by heating the evaporation of solvent into a gaseous state, the steam into the cooling system to flow out, so that the recovery of organic solvents. So as to make the waste, dirty, old organic solvent recycling, recycling and reuse. Both can save a lot of procurement costs, but also to reduce the pollution of the environment.
Cleaning agent recovery machine,Recyclable solvent,Recoverable solvent species
Maintenance of the granule packing machine is essential for long-term use.