Rinse the inside and outside of the harvester with washing water, clean the wrapped grass and other debris, remove the chain and soak it with diesel oil until the oil sludge is brushed, then soak in oil for 5-10 minutes, remove the oil, and apply grease to the kraft paper or plastic. Bags are placed in a dry place. After the warehouse is thoroughly cleaned, the harvester is driven into the hangar. The inorganic warehouse shall be covered with a simple shelter against rain and sunlight. The diesel, oil filling port, air filter, and exhaust pipe mouth shall be wrapped in plastic bags. Dust-proof soil enters. Put the engine off and put the oil in the oil pan hot and let out the diesel oil of the diesel engine. After the water temperature drops, turn on the cooling water components such as the water tank and the body to release the cooling water. Remove all the belts, wipe them clean, and inspect them for damaged conditions. Record the belt position marks, store the talcum powder hanging in the cool and ventilated place inside the hangar, remove the main electrical appliances such as generators and headlights, and keep them properly. Remove the battery and store it indoors to charge it. Inspect and inspect worn and deformed parts, and focus on inspecting parts that have malfunctioned during the operation, and repair and replace them in time. In the use of anti-corrosion harvesters often sun, rain, friction, collision, to prevent corrosion, paint or spray paint in a timely manner. Apply anti-corrosion oil or grease to adjustment bolts and safety clutch claws around the cutter. Relax and relax the springs in each part so that they are not compressed. All parts of the hydraulic cylinder should be in the inoperative position. Lubrication A thorough lubrication of the components is performed according to the requirements of the harvester lubrication diagram. Safekeeping measures shall be taken in the place where the harvester is kept. Monthly engine cylinder, to add a little oil, at least to shake the crank 1-2 times, operate the hydraulic handle dozens of times. Put up the jacks and fasten them with a square wooden pad to make the front and rear wheels off the ground, lower the header and reel to the lowest position and put them on the wood. The non-invasive/high-flow integrated ventilator (BPAP-HE) is a non-invasive ventilator, a high-flow respiratory humidifier, or a high-performance humidifier. BPAP HE,Non Invasive Vent,Niv Breathing Machine,Non Invasive Ventilation Machine Shenyang RMS MEDICAL TECH CO.,LTD , https://www.medicalrms.com
The non-invasive ventilator mode of this product can be used for adult patients who do not rely on invasive ventilation support, such as respiratory dysfunction, to provide ventilation assistance and respiratory support;
Products with high-flow heating and humidification mode can be used for humidification and oxygen therapy for adult patients with spontaneous breathing.