Posted on

The positive pressure sealing performance tester is suitable for the sealing test of plastic flexible packaging parts and plastic bottles, cans and other products. Through the test, the sealing process and sealing performance of the flexible packaging parts can be effectively compared and evaluated. The positive pressure sealing performance measuring instrument is food, pharmaceutical, An ideal testing instrument for industries such as Japan. The positive pressure sealing performance tester is a sealing performance tester with superior performance and high cost performance. The whole machine is beautiful in appearance, the shell is made of high quality stainless steel, and the air sealing and stopping parts are all imported from Germany and domestic high quality parts, including probe. Seal Rubber column PET cap clamp. Cutter. Sealing performance is better than domestic similar models. It can be tested without air source. Stainless steel shock meter indication control table and timing controller adopt imported joint venture brand, with high precision value and superior performance.

Positive pressure sealing performance tester

Positive pressure sealing performance tester system parameters:

Air pressure indication range: 0 ~ 1.5MPa.

Power source: 220V/50Hz Exhaust pipe: Φ8mm Taiwan imported high quality polyester TPU pipe

Sealing performance standards: in line with national and international standards: ISO, GB/T 10440-2008, BB/T0025-2004, etc.

Positive pressure sealing performance tester steps:

  1. Check whether the sealing tester sealing pipe is connected correctly (the body is installed, do not disassemble), whether the sealing barrel is placed properly, whether the water level is suitable for the water test, and whether the test sample is ready, please complete the preparation before the test.
  2. Adjust the pressure on the right side of the machine to the required measurement pressure, and need to deflate and shut off the gas. (Toggle the knob to adjust, push the lock)
  3. Prepare the sample and punch it with the matching puncher

4. Install the matching needle into the push hole

5. After inserting the matching needle into the hole, after rotating it left and right a few times, loosen the stainless steel until it is clamped on the bottle cap.

6. Put it into the test bucket for testing.

7. After the test is completed, tighten the stainless steel knob, then push it to the side of the bottle, then turn it off or cut it with scissors, pay attention to safety.

8. After the test is completed, the test air source is turned off, and the test sample can be removed after deflation.

Positive pressure sealing performance tester notes:

  1. After the test is completed on the day, please unplug the power cord to ensure safety. At the same time, pull the red safety valve on the gas tank to deflate.
  2. Please note! ! ! The test water in the seal tester should be replaced once a week. Do not pour the water in the sealed bucket. Be sure to seal the water in the bucket with a container to avoid deformation and leakage of the sealed barrel. Although the sealed barrel is made of high quality plastic, it is plastic. ,Please note! ! !

Label: Positive pressure seal performance tester

YT-T15

The best choice for Analog hearing aids with earbuds design

The best choice for Analog hearing aids with earbuds design

Shenzhen Sunshine Technology Co.,Ltd , https://www.shenzhenyatwin.com